MIL-P-29228A(YD)
3.17 System of measurement. The dimensions used in this specification are
not intended to preclude the use of the metric system of measurement in the
fabrication and production of the material, individual parts, and finished
product, provided form, fit, and function requirements are satisfied.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements (examinations and tests) as specified herein.
Except as otherwise specified in the contract or purchase order, the contractor
may use his own or any other facilities suitable for the performance of the
inspection requirements specified herein, unless disapproved by the Government.
The Government reserves the right to perform any of the inspections set forth
in this document where such inspections are deemed necessary to ensure
supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items shall meet all requirements
of sections 3 and 5. The inspection set forth in this document shall become a
part of the contractor's overall inspection system or quality program. The
absence of any inspection requirements in this document shall not relieve the
contractor of the responsibility of ensuring that all products or supplies
submitted to the Government for acceptance comply with all requirements of the
contract. Sampling inspection, as part of manufacturing operations, is an
acceptable practice to ascertain conformance to requirements, however, this does
not authorize submission of known defective material, either indicated or
actual, nor does it commit the Government to accept defective material.
4.1.2 Material inspection. The contractor is responsible for insuring that
supplies and materials are inspected for compliance with all the requirements
specified herein and in applicable referenced documents.
4.2 Classification of inspectons. The inspection requirements specified
herein are classified as follows:
a. First article inspection (see 4.2.1).
b. Quality conformance inspection (see 4.2.2).
4.2.1 First article inspecton. The first article inspection will be
performed on one extractor when a first article is required (see 3.2 and 6.2).
This inspection shall include the examination of 4.4.1, the test of 4.4.2, and
the detection of failure 4.4.3. The first article may be either a first
production item or a standard production item from the supplier's current
inventory provided the item meets the requirements of the specification and is
representative of the design, construction, and manufacturing technique
applicable to the remaining items to be furnished under the contract.
4.2.2 Quality conformance inspection. The quality conformance inspection
shall include the examination of 4.3, the test of 4.4.4, and the packaging
inspection of 4.5.
4.3 Examination. Each extractor shall be examined for compliance with the
requirements specified in section 3 of this specification. Any redesign or
modification of the contractor's standard product to comply with specified
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business