MIL-R-29385A(MC)
* 3.3.1 Characteristics.
The roller shall conform to the following
characteristics:
30,000
Weight, Maximum (pounds (lb)) 1/
20,000
Weight, Minimum (lb) 1/
102
Height, Maximum (inch (in)) 2/
106
Width, Maximum (in)
240
Length, Maximum (in)
84
Drum Length, Maximum (in) 3/
27
Steering Articulation (degrees in each direction)
Travel Speed, Miles Per Hour (mi/h)
0-4
Low Range, Minimum
0-8
High Range, Minimum
3.3.2 Engine. The engine for the roller covered by this specification
shall be a liquid cooled diesel engine with sufficient power and speed
rating so that operation of the roller under any of the operational
requirements and conditions specified herein will not require horsepower
in excess of the intermittent horsepower rating of the engine for the
applicable governed speed as established by the engine manufacturer. The
engine shall be mounted on rubber isolators to reduce noise and vibration.
The engine shall be capable of operating and meeting the performance
specified herein on diesel fuel conforming to VV-F-800 and JP-5 turbine
fuel conforming to MIL-T-5624.
* 3.3.2.1 Starting system. The engine shall be furnished with a 12-volt
electric starting system with sufficient batteries to crank the engine
under all conditions specified herein.
3.3.2.2 Engine lubrication system. The engine lubrication system shall
provide lubrication for all roving engine parts for continuous operation.
The lubrication system shall be a full pressure type system. The roller
shall have oil drain provisions for draining the engine crankcase. A
bayonet gage or dipstick which is calibrated for determining crankcase oil
level shall be provided.
1/ Weight shall include fully serviced and fueled roller with padfoot
drum module, pintle hitch, tires as specified and furnished as an
integral part of the roller and roll-over protection structure, but shall
riot include operator.
2/ Without roll-over protection structure; roll-over protection
structure required but must be detachable.
3/ Maximum length applies to both smooth and padfoot type drum modules.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business