MIL-R-3206 Reeling Machine, Cable, Hand, Rl-39This specification covers one type of light-weight, hand-reeling machine used for laying and recovering infantry field wire WD-1 /TT; designated Reeling Machine RL-39 . see 6.1.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16

Mil.-F-3206B

4.3   Inspection covered by   subsidiary documents.    The  following shall  be inspected  under  the  applicable subsidiary documents as  part of  the  acceptance inspection before  preparation for  delivery:

Item Welding Tropicalization Finish

Marking

W ·ere  required

3.2.4

3.2.5

3.2.7

3.2.8

4.4    Quality con1'ormance inspection of  product before  preparation for  delivery. The  contractor,  to  demonstrate compliance with    specified requirements,  shall  perD form  the  inspection specified  in  4.3  �d  4.4.l  through  4.4.4.   This  does  not relieve  the  contractor  of  his  responsibility for  perfonning any  additional

inspection which  is  necessary  to  control  the  quality of  the product  and  to  assure

compliance "'1.th  all  specificbtion requirements.   The  Government vill  review and

evaluate  the  contractor's inspection procedures and  examine  the  contractor's

inspection  records.    In  addition,  the  Government,  at  its  discretion,  may  perform

all  or  any  part  of .the  specified inspection,  to  verify  the  contractor's compliance

with  specified requirements.   Test  equipment  for  Government  verification inspection

shall  be  made  available by  the  contractor.

4.4.l   Group  A  inspection.    Each  unit  (100  percent)  of  each  lot  of  reeling machines  shal.l be  inspected for  con1'onnance  to  all  inspection and  test requirements of  Table  I.    F.ach  lot  vill  be  subject  to  verit'ication, utilizing the  procedures of  MIL-STD-105 using general inspection  levels  and  the  AQL's indicated  in  Table  I.    Group A  inspection shall be  performed  inaru order  which is  satisfactory to  the  Government.

Table  I.    Group A  inspection.

*Operational defects  are  considered ma.1or.

�.4.2   Group  B  inspection.   'Olis  inspection including  sampling,  shall  conform to  Table  II  and  to  the  special procedures  for  small  sample  inspection of

Mll.-STD-105.    The  AQL  shall  be  6.5  percent defective and  the  inspection level shall  be  S-4.    Group  B  inspection shall  be  performed on  inspection lots  that

have  passed  group A  inspection and  on  samples  selected  from  units  that have  been subjected  to  and  passed  the  group  A  inspection.

6

Source:  https://assist.dla.mil  --  Downloaded:  Check  the  source  to  verify  that  this  is  the  current  version  before  use.

---------------