MIL-P-29196B(YD)
the surfaces shall be prepared or treated to insure the adhesion of the coating
system. The painting shall consist of at least one coat of primer and one
finish coat. The primer shall be applied to a clean, dry surface as soon as
practicable after cleaning and treating. Painting shall be with manufacturer's
current materials according to manufacturer's current processes and the total
dry film thickness shall be not less than 2.5 mils over the entire surface. The
paint shall be free from runs, sags, orange peel, or other defects.
3.20 Lubrication. Unless otherwise specified in 5.1, lubrication shall be
in accordance with the manufacturer's recommendations. Pressure lubrication
shall not damage seals or other parts. All parts requiring lubrication shall be
lubricated prior to delivery and tagged to show the type and temperature rating
of the lubricant used. Hydraulic lubrication fittings shall conform to SAE
J534.
3.21 Instruction plates. The paver shall be equipped with instruction
plates suitably located, describing any special or important procedures to be
followed in operating and servicing the equipment. The plate shall be of a
material which will last and remain legible for the life of the equipment, and
shall be securely affixed thereto with nonferrous screws or bolts of not less
than 1/8-inch diameter.
* 3.22 Identification plate. A name plate will be furnished by the
contracting officer for each paver. The contractor shall stamp all necessary
data in the blank spaces of the plate provided for that purpose, and securely
affix a plate to each paver in a conspicuous place with brass or stainless steel
screws, rivets or bolts not less than 1\8 inch in diameter. The applicable
nomenclature contained in the contract item description shall be placed in the
top blank.
3.23 Lifting and tiedown attachments. The paver shall be equipped with
lifting and tiedown attachments. Lifting and tiedown attachments shall conform
to type II or type III of MIL-STD-209. A nonferrous transportation plate shall
be provided and mechanically attached to the paver.
Transportation plates shall be inscribed with a diagram showing the lifting
attachments and lifting slings, the capacity of each attachment, and the
required length and size of ezch sling cable. A silhouette of the item
furnished showing the center of gravity shall be provided on the transportation
plate. Tying down attachments may be identified by stenciling or other suitable
marking. Tiedown marking shall clearly indicate that the attachments are
intended for the tie down of the paver on the carrier when shipped.
3.24 Workmanship.
3.24.1 Steel fabrication. The steel used in fabrication shall be free
from kinks, sharp bends, and other conditions which would be deleterious to
the finished product. Manufacturing processes shall not reduce the strength
of the steel to a value less than intended by the design. Manufacturing
processes shall be done neatly and accurately. All bends shall be made by
controlled means to insure uniformity of size and shape.
3.24.2 Bolted connections. Boltholes shall be accurately punched or drilled
and shall have the burrs removed. Washers or lockwashers shall be provided in
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business