OO-R-2853
dry surface as soon as practicable after cleaning and treating. Painting shall
be with manufacturer's current materials according to manufacturer's current
processes and the total dry film thickness shall be not less than 2.5 mils
(0.0635 mm) over the entire surface. The paint shall be free from runs, sags,
orange peel, or other defects. All allied equipment and attachments shall be
the same color.
3.20 Lubrication. Means for lubrication shall be in accordance with the
manufacturer's standard practice. The lubricating points shall be easily
visible and accessible. Hydraulic lubrication fittings shall be in accordance
with SAE J534. Where use of high-pressure lubricating equipment will damage
grease seals or other parts, a suitable warning shall be affixed to the
equipment in a conspicuous location. The unit. shall be lubricated prior to
delivery with type of lubricant specified in the operator's manual and grade of
lubricant recommended for ambient temperature at the delivery point. The unit
shall be conspicuously tagged to identify the lubricants and their temperature
range.
3.21 Workmanship.
3.21.1 Steel fabrication. The steel used in fabrication shall be free from
kinks, sharp bends, and other conditions which would be deleterious to the
finished product. Manufacturing processes shall not reduce the strength of the
steel to a value less than intended by the design. Manufacturing processes
shall be done neatly and accurately. All bends shall be made by controlled
means to insure uniformity of size and shape.
3.21.2 Bolted connection. Bolt holes shall be accurately punched or
drilled and shall have the burrs removed. Washers, lockwashers or other locking
devices shall be provided in accordance with good commercial practice, and all
bolts, nuts, and screws shall be tight.
3.21.3 Riveted connections. Rivet holes shall be accurately punched or
drilled and shall have the burrs removed. Rivets shall completely fill the
holes. Rivet heads, when not countersunk or flattened, shall be of approved
shape and of uniform size for the diameter of rivet. Rivet heads shall be full,
neatly made, concentric with the rivet holes, and in full contact with the
surface of the member.
3.21.4 Welding. Welding procedures shall be in accordance with a nationally
recognized welding code. The surface of parts to be welded shall be free from
rust, scale, paint, grease, or other foreign matter. Welds shall transmit
stress without permanent deformation or failure when the parts connected by the
weld are subjected to proof and service loadings.
3.22 System of Measurement. The dimensions used in this specification are
not intended to preclude the use of the metric system of measurement in the
fabrication and production of the material, individual parts, and the finished
product, provided form, fit, and function requirements are satisfied.
QUALITY ASSURANCE PROVISIONS
4.
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance of
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business